AudioBahn MULTIFUNCTIONAL SOURCE UNIT A3351 - Manual (Page 37)

Installation Procedure
1. To prevent a short circuit, remove the key from the ignition and disconnect the (-) battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the speaker wires of the wiring harness
4. Connect the wiring harness connector in the following order : Ground, Battery, Ignition.
5. Connect the wiring harness connector to the unit
6. Install the unit in your car
7. Reconnect the (-) battery
8. Press the reset button
Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and
secure the unit with the accessory screws.
N O T E : This installation method is a reference example. Make sure that the
unit is installed securely in place. If the unit is unstable, it may malfunction
(for example, the sound may skip)
Installation
Installation
35