Mounting the stk505 – Atmel STK500 User Manual
Page 4
4
Mounting the STK505
The first thing you should do is to mount the STK505 onto the STK500.
1. Turn off the power on STK500.
2. Remove any other top card from the STK500.
3. Remove any AVR mounted in any of the sockets on the STK500.
4. Place the STK505 on top of the STK500. Make sure the EXPAND0 and
EXPAND1 connectors on both cards align properly.
See also other documents in the category Atmel Hardware:
- 8-bit Microcontrollers with Integrated USB Controller (4 pages)
- ATAK2270 (39 pages)
- ATA5283 (14 pages)
- ATAVRAUTO200 (21 pages)
- Evaluation Board AT91SAM9XE-EK (34 pages)
- AT88SC0104CRF (2 pages)
- ATSTK94 (2 pages)
- Dual Triple DMOS Output Drivers with Serial Input and PWM Control T6819 (2 pages)
- ATAVRAUTO100 (19 pages)
- AVR XMEGA 8/16-bit High Performance Low Power Flash Microcontrollers (12 pages)
- SpaceWire Router SpW-10X (155 pages)
- AT91CAP7A-STK (2 pages)
- ATAVRAUTOEK1 (5 pages)
- Microcontroller with LIN Transceiver ATA6603 (2 pages)
- AT85RFD-07 (10 pages)
- STK501 (2 pages)
- AT91SAM7L-STK (40 pages)
- AVR2070 (93 pages)
- ATmega324PA (30 pages)
- ATmega88PA (26 pages)
- AT91CAP7E (2 pages)
- AVR2016 (25 pages)
- AT88RF020 (2 pages)
- AT91SAM7XC (2 pages)
- C51 (27 pages)
- Diopsis 940HF (2 pages)
- AVR AT90S8515-4 (13 pages)
- AT89C5132 (38 pages)
- AT85DVK-07 (21 pages)
- AT91CAP7X-DK (2 pages)