Bosch TCC78K751 Edelstahl Kaffeevollautomat - Manual (Page 45)

English | 47
Bosch TCC78K751 | 07/2011
Preparing milk froth
and warm milk
Risk of burns
The milk frother (12) gets very
hot. After use, allow to cool
down i rst before touching.
For optimal milk froth quality,
use cold milk with a fat content
of at least 1.5 % if possible.
1. Take the milk tube and connect it to
the milk frother (see “Preparation using
milk”).
2. Place a cup or glass under the outlet of
the milk frother (12).
3. Select the required Milk froth or Warm milk
setting by turning the rotary knob (5):
( Milk froth )
M
4. Press o start/stop (10); milk froth or
warm milk runs out of the milk frother
outlet (takes about 40 or 60 seconds
respectively).
Press o start/stop (10) again to cut the
process short.
The appliance may make a
whistling noise when warm
milk is being prepared. This
is caused by the milk frother
(12) for technical reasons.
Dried milk residue is difi cult to
remove, so clean the milk frother
immediately after use
(see “Cleaning the milk system”).
Dispensing tea water
Risk of burns
The milk frother (12), from
which the tea water l ows, gets
very hot. After use, allow to cool down
i rst before touching.
The appliance can also be used to prepare
tea.
1. Place a cup or glass under the coffee
outlet.
2. Select Tea water with the rotary knob
(5):
( Tea water )
L
a
}
3. Press p (4) to switch to the temperature
selection. Set the required temperature
with the rotary knob (5):
( Tea water )
L
c
}
4. Press o start/stop (10); hot water runs
out of the milk frother outlet for about
40 seconds.
Press o start/stop (10) again to cut the
process short.
Warm up cups before use,
especially small, thick espresso
cups, with the hot water.
TCC78K751_Heft1.indb 47 28.06.2011 11:44:21