Bosch TES80751DE VeroSelection 700 Kaffeevollautomat Edelstahl - Manual (Page 44)

40
Robert Bosch Hausgeräte GmbH
en
If no new filter 29 is used, turn the
Water filter setting to no .
Info: If the appliance has not been used
for a prolonged period (for example, when
you are on vacation), the existing filter 29
should be rinsed before the appliance is
used again. To do this, simply dispense a
cup of hot water.
Transport. lock
● To avoid damage caused by frost during
transport and storage, the appliance must
be completely emptied first.
Info: The appliance must be ready for use
and the water tank 11 filled.
● Press the start button 8. The appliance
automatically empties the pipe system
and switches off.
● Empty the water tank 11 and the drip
tray 23.
Factory reset
You can cancel your own settings and reset
the factory settings.
● To activate the factory settings, press the
start button 8.
Info: The appliance can also be reset to
the factory settings using a combination of
buttons. The appliance must be switched
off fully.
● Hold down the selection buttons < and >
4 and the on/off switch 1 O / I at the same
time for at least 5 seconds. Press the
start button 8. The factory settings are
now reactivated.
Preparation using
coffee beans
This fully automatic espresso machine
grinds beans freshly for each brew. If pos-
sible, use only beans for fully automatic
coffee and espresso machines. For optimal
quality, deep-freeze the beans or store in
a cool place in sealed containers. Coffee
beans can be ground while frozen.
Important: Fill the water tank 11 with cold,
fresh water every day. The water tank 11
should always contain sufficient water for
operating the appliance.
Tip (only TES807): Pre-warm cups,
especially small, thick espresso cups, on
the cup warmer 27.
Different coffee drinks can be prepared
quite simply at the press of a button.
Note: With some settings, the cof-
fee is prepared in two stages (see
“ aromaDouble Shot”). Wait until the proce-
dure is fully completed.
Drink preparation without milk
The appliance must be ready for use.
● Place the pre-warmed cup(s) under the
coffee outlet 9.
● Select the required 2 x Espresso  ,
2 x Coffee à , Espresso À or Coffee Á
by turning the rotary knob 6.
The display 5 shows the selected drink
along with the setting for coffee strength
and per-cup quantity for this drink.
Espresso
Л Н
В Г А Б Е Ж
TES803_805_807_1DE.indb 40 08.05.2013 14:55:08