Aruba Spa 2003 Serenade - Manual (Page 14)

icals to adjust the water balance (see Chemical Maintenance,
page 19).
7) The spa pack is thoroughly tested before shipping. The
most common cause of immediate pack failure is dry firing
(this occurs if the pump is running and the water is not cir-
culating) and this type of failure is not covered by warranty.
8) If you experience any problems with the procedures above
contact an Aruba customer service representative.
9) After your spa is operational you must install the Spa
Cover latches. The locks will already be attached to the end
of the straps. Position the tie strap so it is fully extended,
without stretching. Locate the 2 holes on the locking mecha-
nism, marking them with a pen. Remove the locking mecha-
nism from the strap and fasten to the spa.
SP SP A OPERA A OPERA TIONS GUIDE TIONS GUIDE
T T opside Contr opside Contr ol Component Identification ol Component Identification
Heat Heat s and Heat and Heat t buttons buttons
The spa’s thermostat is to provide you with optimum control
of the spa water temperature. This temperature set point can
be adjusted from 21° C (70° F) to 40° C (104 degrees F).
Invert Button Invert Button
This button will flip the LED readout 180°.
HAZARD
Never leave an uncovered spa unattended,
and never leave a covered spa unlatched.
12