Audiovox HOME BASE DPF711K - Manual (Page 9)

9
INSTALLATION (cont’d)
Wall Mount Installation Using the Wall Mount Bracket
NOTE: To mount the homebase to a wall using the adhesive pads, follow the same instructions
indicated earlier in “refrigerator surface installation” – page 7.
To mount using screws, proceed as follows:
1. Position the mounting template against the wall at the desired location; level the top of the tem-
plate, and mark the position of the two upper holes onto the wall.
2. Using a 1/4” (6mm) drill bit, drill two holes where you marked the wall; if a wall stud is not present,
insert the provided plastic anchors into the holes until they are flush with the wall.
3. Align the wall bracket with the two drilled holes and/or wall anchors; insert the two flat-head
screws provided, and secure the wall bracket to the wall.
CAUTION: Do not over tighten the screws; doing so may damage the wall bracket.
4. Connect the power adapter plug to the DC input connector at the rear of the homebase.
5. Determine how best to route the power adapter wire in reference to the AC wall outlet – to the left
or right side of the homebase – and slip the DC wire into the corresponding wire notch on the back
of the unit.
6. heck the amount of wire required to reach the AC outlet; spool any excess wire onto the four posts
inside the rear hollow of the homebase.
7. Attach the homebase to the bracket by lining up the homebase bracket mounting holes with the
wall bracket mounting tabs, and slide the homebase down until the mounting tabs engage the
mounting hole slots.
8. Cover the power adapter wire with either the clear, black or white wire cover; seal the cover using
the double-sided tape provided, and then press into place, adhering it onto the wall surface.
DPF711K
Drill 1/4" Hole
(2 Places)
Wall Surface
Plastic Wall
Anchor (2) if
Needed
Flat-Head Self-Tapping
Screw (2)
Wall Bracket
Mounting Tabs Wall Mount
Bracket
Mounting Hole
Template
HB-711-OM-128-8270-Eng.qxp 6/5/08 9:37 AM Page 9