Control Company 1081 WORKSTATION BAROMETER WITH CLOCK User Manual
Page 2

TRACEABLE
WORKSTATION
BAROMETER
WITH CLOCK
INSTRUCTIONS
WEATHER FORECAST
The weather forecast is based on the changes in
barometric pressure over the past 12 hours. The
weather forecast symbols do not necessarily reflect
the current weather conditions, they are a forecast
of future conditions. The accuracy of the weather
forecast is about 70 to 75%.
Forecast Symbol Meanings
clear partly cloudy light heavy
cloudy rain rain
TIME-OF-DAY ALARM/SNOOZE
1. While in the normal display mode, press the
+ or – buttons to display and adjust the
time-of-day alarm time.
2. To activate the time-of-day alarm, move the
slide switch (located on the side of the unit) to
the “AL ON” position.
With the time-of-day alarm activated, when the
alarm time is reached the alarm will sound. Each
press of the SNOOZE button will silence the alarm
for 5 minutes (Zz will appear on the display).
To turn off the alarm, move the slide switch to the
“AL OFF” position.
DISPLAY ILLUMINATION
The unit features a back-light with 2 modes of
illumination for viewing in low light conditions.
Pressing the SNOOZE button will fully illuminate
the display for approximately 3 seconds.
Moving the slide switch (located on the side of the
unit) to the NIGHT LIGHT position (AL OFF or AL
ON) will provide a continuous low level illumination
of the display. (This level of illumination is only
visible under low light conditions).
ALL OPERATIONAL DIFFICULTIES
If the Altitude Adjustment is incorrectly set, it may
cause the barometric pressure reading to be
out-of-range. See the “Altitude Adjustment” section
and adjust the altitude to correct this difficulty. If
the temperature reading is out-of-range, the unit
must be placed in an environment that is within the
thermometer’s specified temperature range.
If this barometer does not function properly for
any reason, replace the batteries with new high
quality batteries (see the “Battery Replacement”
section). Low battery power can occasionally
cause any number of “apparent” operational
difficulties. Replacing the batteries with new fresh
batteries will solve most difficulties.
®
BATTERY REPLACEMENT
Erratic readings, faint readings, or no display are
all indications that the batteries must be replaced.
Remove the battery cover by sliding it in the
direction indicated by the arrow. Remove the
exhausted batteries and replace them with three (3)
new AAA alkaline batteries. Make certain to install
the new batteries in the directions indicated in the
battery cover. Replace the battery cover. When
the batteries are replaced, the barometer returns to
the default settings. The following will need to be
set after replacing the batteries: Time-of-Day/Date,
Units of Measure, and Altitude Adjustment.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA.
Control Company Cat. No. 1081
Traceable
®
is a registered trademark of
Control Company.
©
2013
Control Company.
92-1081-00 Rev. 0 070913
TRACEABLE
WORKSTATION
BAROMETER
WITH CLOCK
INSTRUCTIONS
WEATHER FORECAST
The weather forecast is based on the changes in
barometric pressure over the past 12 hours. The
weather forecast symbols do not necessarily reflect
the current weather conditions, they are a forecast
of future conditions. The accuracy of the weather
forecast is about 70 to 75%.
Forecast Symbol Meanings
clear partly cloudy light heavy
cloudy rain rain
TIME-OF-DAY ALARM/SNOOZE
1. While in the normal display mode, press the
+ or – buttons to display and adjust the
time-of-day alarm time.
2. To activate the time-of-day alarm, move the
slide switch (located on the side of the unit) to
the “AL ON” position.
With the time-of-day alarm activated, when the
alarm time is reached the alarm will sound. Each
press of the SNOOZE button will silence the alarm
for 5 minutes (Zz will appear on the display).
To turn off the alarm, move the slide switch to the
“AL OFF” position.
DISPLAY ILLUMINATION
The unit features a back-light with 2 modes of
illumination for viewing in low light conditions.
Pressing the SNOOZE button will fully illuminate
the display for approximately 3 seconds.
Moving the slide switch (located on the side of the
unit) to the NIGHT LIGHT position (AL OFF or AL
ON) will provide a continuous low level illumination
of the display. (This level of illumination is only
visible under low light conditions).
ALL OPERATIONAL DIFFICULTIES
If the Altitude Adjustment is incorrectly set, it may
cause the barometric pressure reading to be
out-of-range. See the “Altitude Adjustment” section
and adjust the altitude to correct this difficulty. If
the temperature reading is out-of-range, the unit
must be placed in an environment that is within the
thermometer’s specified temperature range.
If this barometer does not function properly for
any reason, replace the batteries with new high
quality batteries (see the “Battery Replacement”
section). Low battery power can occasionally
cause any number of “apparent” operational
difficulties. Replacing the batteries with new fresh
batteries will solve most difficulties.
®
BATTERY REPLACEMENT
Erratic readings, faint readings, or no display are
all indications that the batteries must be replaced.
Remove the battery cover by sliding it in the
direction indicated by the arrow. Remove the
exhausted batteries and replace them with three (3)
new AAA alkaline batteries. Make certain to install
the new batteries in the directions indicated in the
battery cover. Replace the battery cover. When
the batteries are replaced, the barometer returns to
the default settings. The following will need to be
set after replacing the batteries: Time-of-Day/Date,
Units of Measure, and Altitude Adjustment.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA.
Control Company Cat. No. 1081
Traceable
®
is a registered trademark of
Control Company.
©
2013
Control Company.
92-1081-00 Rev. 0 070913