Nokta detectors RS Pinpointer - Manual (Page 2)

NOKTA ENGINEERING
INTRODUCTION
WARNINGS and REMINDERS
Thank you for choosing and purchasing our Nokta RS Pinpointer.
Nokta RS Pinpointer is a hand-held metal detector designed to pinpoint targets
detected by conventional metal detectors.
Do not expose the device to very hot (for example, inside a hot car) or cold conditions
for extended periods of time.
RS Pinpointer is not a digging tool. Do not use it for digging or extracting stones or
metals.
Only the end of the probe is waterproof. Do not immerse the control box in water; do
not expose the device to extreme humid conditions.
Do not use the device to locate power lines. Using the device near power lines may
cause harm to the device.
Always keep the device off when not in use. This will help increase battery life and
device performance.
Sudden changes in ambient temperature can drastically affect the performance of
the device. Therefore, it is recommended not to use the device immediately after sudden
temperature changes but to wait for approximately 10 minutes.
Audio alert consumes less battery power than vibration alert. Using the audio alert
when possible will extend battery life.
For Consumers within the European Union: Do not dispose of this equipment in general
household waste. The crossed wheeled bin symbol on this equipment indicates this unit should
not be disposed of in general household waste, but recycled in compliance with local
government regulations and environmental requirements.
Audio / Vibration / Off Battery Cover Light Sensor 360° Detection
Waterproof Pinpointing Tip
LED Flashlight
FCC STATEMENT: This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.