Assembly, Nokta engineering – Nokta detectors Velox One User Manual User Manual
Page 8
ASSEMBLY
Wrap the coil cable around the shaft all the way up
as shown in the picture and after inserting it in the
coil input socket underneath the system box,
secure it by twisting the connector. Pay attention
to not wrap the cable too tight during this step.
7
Place the washers into the openings on both sides
at the end of the extension shaft. After placing the
shaft on the coil as shown in the picture, insert the
fastening screw through the hole and tighten it
using the wingnut.
NOKTA ENGINEERING
To carry the battery case on your waistband: Insert
the battery case in the leather cover. As shown in the
picture, attach the clip to the backside of your belt.
Plug the battery case cable into the socket
underneath the system box and tighten securely.