Diamond Products CB700 Drill Motor - Manual (Page 13)

MAINTENANCE
1. General Rules
A. Always clean the machine before performing any maintenance/repair.
B. A clean machine makes visual inspection for problems easier to notice.
2. Steps to Follow When Cleaning
A. Please do not use aggressive cleaners (i.e. containing solvents). Do not use
high-pressure water jets, aggressive detergents or solutions and liquids with a
temperature exceeding 86ºF! Use a fluff-free cloth only.
B. For the sake of safety, no water/cleaning liquid/vapor may penetrate into the
electric motor, connectors/plugs, switches, etc. Cover all apertures, holes in the
housing, connectors or plugs, etc. or seal them with adhesive tape!
C. Use a cloth which may be lightly moistened only for removing dust and dirt.
Hard packed dirt can be removed with a soft brush.
D. After cleaning, remove all covers and adhesive tape! All screws/nuts which
you may have loosened must be tightened again! After wet cleaning, try the
machine on a power outlet which is equipped with a power breaker (i.e. fault
current circuit breaker). If the fault current circuit breaker cuts the power supply,
the machine must be inspected by an authorized dealer prior to use!
WARNING: For your safety, before performing any maintenance on the drill turn
OFF the power switch and UNPLUG the power cord.
12