Diamond blades, Inspecting the blade, Blade speed – Diamond Products CC155 User Manual
Page 14: Installing the blade

10
Diamond Blades
WARNING
• DO NOT exceed the blade’s
maximum speed when
cutting. Excessive blade
speeds can cause blade
breakage, resulting in
serious injuries and/or death.
• DO NOT use damaged blades when
cutting to avoid harming yourself, others,
or the saw.
• Always use the correct blade type for the
material being cut.
Using the proper blade (size and type) preserves
the blade and improves cutting and operator
efficiency, resulting in lower costs. Refer to the
Association of Equipment Manufacturers (AEM)
safety brochure for diamond blades or
information.
Inspecting the Blade
Always inspect each blade prior to installation.
Discard all damaged blades and inspect each
replacement blade for:
• Cracks, nicks, and dents
• A damaged and/or deformed arbor (center hole)
• Darkness and/or discoloration near the edge of
the blade
• A deformed blade circumference
• Segment loss and/or segment cracks
• Core wear
• Bending
• Uneven side-widths
Blade Speed
Refer to the blade packaging information or to the
information printed on the blade for the maximum
recommended blade speeds when cutting. DO
NOT exceed the maximum recommended speed
while cutting. DO NOT use a blade that is rated
with a lower maximum operating speed than the
blade shaft speed.
Installing the Blade
WARNING
• DO NOT install a blade with
the engine running.
• Failure to properly secure the
outer flange and blade may cause parts to
loosen or fall off of the saw.
CAUTION
• Wear gloves and be alert to the
surrounding environment when handling
blades.
1. Raise the saw.
2. Remove the lock knob from the backside of the
blade guard.
3. Pivot the blade guard up, over 90°, to gain
access to the blade flanges. Note: Failure to
fully pivot the guard may cause injuries
4. Remove the blade shaft nut. Turn the nut
counterclockwise to loosen.
.
5. Carefully pull the outer flange off of the blade
shaft.
Figure 7: Removing the Outer Flange
6. Inspect the nut, outer flange, and inner flange
for damages and clean, repair, or replace as
necessary.
7. Inspect the blade for damages. DO NOT use
blades that are too large or too small for the
saw.