Multichannel Systems ADPT-NN-8 - Manual (Page 2)

ADPT-NN-8
8-Electrode NeuroNexus Probe
Adapter for MPA8I Amplifier
Connecting the NeuroNexus Probe to the adapter ADPT-NN-8
Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
© 2012 Multi Channel Systems MCS GmbH
Product information is subject to change
without notice.
G and R have been connected together as factory-default settings to a 0 Ohm resistor (ORO).
Important: Operation of the MPA8I is differential. The reference channel R has to be used for obtaining
a proper signal. Please see the MPA8I manual for details.
On the left picture the input pins of the adapter ADPT-NN-8 are shown that are connected to the probe.
On the right picture the output pins of the NeuroNexus probe are shown that are connected to the
adapter. In the middle you have the pin layout of the MPA8I: The labeled channels are the ground channel
(GND shielding), the reference channel (REF input), and the 8 recording channels (1 to 8) of the MPA8I.
The ground channel connected to pin 11 of the MPA8I input pins is the power ground (GND power).
Please see the MPA8I manual for details. If you use MC_Rack for data acquisition, see Pin Layout above.
Complete setup with NeuroNexus probe, adapter ADPT-NN-8 and MPA8I
NeuroNexus Probe
MPA8I
ADPT-NN-8
I mportant:
Black side of MPA8I faced down !
CH 4 5 CH
CH 1
CH 2
CH 3
8 CH
7 CH
6 CH
GND
REF
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
GND
GND (shielding)
REF (input)
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
GND (power)
NeuroNexus Probe
Connector Pin Out
MPA8I
Pin
Layout
MPA8I Out MC_Rack Channels
Ground
connector
1
2
3
4
5
6
7
8
9
10
11
ORO
CH 4
CH 1
CH 2
CH 3
5 CH
8 CH
7 CH
6 CH
Top View without probe
Pin Layout ADPT-NN-8
Front Side