MPM MOD-03 - Manual (Page 23)

23
GB
CLEANING AND MAINTENANCE
Before ea
-
ch cleaning, make sure that the device is disconnected from mains.
After use, empty, clean and dry a container. Dump and dirt may be a cause of unpleasant
-
scent.
Before removing dirt and contaminated liquid disconnect the sucking hose (drawing 13),
-
disengage the clamps and lift the engine’s set.
Foam filter can be washed in warm water with some soap or in running water. It should be
-
dried properly before it is put on float chamber again.
ATTENTION: Foam filter must not be cleaned in hot water or washed in a washing
machine.
Check if a valve in float chamber can be moved easily. If necessary, clean it (drawing 14).
-
In order to check if the float works properly lift the engine’s set and shake it.
Check cleanliness of HEPA filter regularly. If a filter is dirty, it must be cleaned. After a
-
longer period of use HEPA filter will lose its properties.
Change it to a new one then.
-
TECHNICAL DATA
Maximum noise level: L
WA
=81dB
Poland
Correct product disposal
(old electric and electronic equipment)
Such symbol is placed on the product on in relevant texts in order to indi-
cate that after its service life, the product must not be disposed with other
waste originating from household. In order to avoid any harmful impact on
the environment and human health in result of uncontrolled waste disposal, the user is
requested to separate the product from any type of waste and to ensure proper recycling
in order to promote repeated use of material resources as permanent practice.
In order to obtain the information about the location and method of the recycling of the
roaster, its users in households should contact their retailer or with the competent local
authority.
The corporate users should contact with their supplier and check the terms stipulated in
relevant purchase agreement. The product must not be disposed and other commercial
waste.
mod-03_instrukcja.indd 23 26-11-08 14:39:47
Power supply: 230V, 50Hz
Maximum wattage: 2400W