MPM MOD-03 User Manual

Page 19

A. Engine’s set. This section includes an engine, a switch and operating elements. Upper

part of this section constitutes HEPA filter used to filter out dust and other small parts

from the air that is blown out. Under a foam filter there is a big, plastic float which, as the

container fills up, raises and cuts off vacuum at the same time informing about a necessity

to empty the container.

A1 – Switch

A2 – HEPA filter case

A3 – HEPA filter

A4 – Cover of HEPA filter case

A5 – Indicator of filter pollution level

A6 – Float chamber

A7 – Foam filter

A8 – Case with a clamp

B. Container. The container section is a middle part of the vacuum cleaner, used as a

container to collect dust and dirty water. This section is attached to engine’s set with

clamps.

B1 – Water container

B2 – Water filter tank

B3 – Water filter sponge

B4 – Water filter tube

B5 – Clamps

B6 – Sucking inlet

B7 – Wheels

B8 – Rubber gasket

C. Hose. This section includes a sucking hose with a handle and sucking tubes. Sucking

attachment is connected with container’s set through putting the hose into sucking inlet.

Sucking tube is connected to a handle. The handle has sucking power regulation. The hose

can be put on engine’s set with the use of hanger.

C1 – Sucking hose

C2 – Handle

C3 – Sucking power regulation

C4 – Connecting element

C5 – Telescopic sucking tube

C6 – Hanger

C7 – Floor and carpet head

D. Additional accessories.

D1 – Handle used to fasten accessories

D2 – Attachment for cracks

D3 – Round brush

D4 – Narrow brush

D5 – Air freshener

mod-03_instrukcja.indd 19

26-11-08 14:39:44