MPM MZE-04 User Manual
Page 14
14
GB
If you don’t know type of fiber a product is made of, determine relevant temperature by means of ironing
a piece which will be not visible when a cloth is worn. Start with the lowest temperature. Increase the
temperature step by step. In case of the silk, wool and artificial fibers, iron products from the internal side
of cloth in order to not cause shining stains. To avoid stains when ironing, avoid use of the spray.
ATTENTION! Start ironing with products which require the lowest ironing temperature.
2. When the control light goes out, wait a while before you start ironing. When you are ironing
the control light can flash from time to time. When the light is off it means the iron has reached
a desired temperature.
HOW TO USE THE IRON
The iron is equipped with the Auto „SHUT OFF” ( „FIRE FIGHTER” – electronic safety system) function.
This is an electronic, safe switching of when the iron is not used for a longer period of time. This safety function
is active when the iron is positioned in the horizontal or vertical position.
Steam ironing.
1. Check if in the water tank there is relevant amount of water.
2. Set a recommended temperature (see: Preparation for use).
3. Set a desired steam settings .
ATTENTION! As of the moment the iron reaches a desired temperature, the iron stars production
of the steam.
No steam ironing.
1. Set the steam controller into the position ( „NO STEAM”).
2. Set a recommended ironing temperature (see: Preparation for use).
After you have finished ironing.
1. Unplug the iron.
2. If you had ironed with the steam, empty the water tank.
3. Stand the iron in a safe place in the vertical position and wait until it gets cold.
Spray function.
This function is intended to remove difficult creases.
1. Check if in the water tank there is relevant amount of water.
2. To make a fiber wet, push the spray button several times.
Steam burst function.
This function works in vertical and horizontal positions. It is greatly useful if you need to remove
creases on hanging clothes, curtains etc.
ATTENTION! Never direct the steam on people!
„ANTI DRIP” function.
The iron is equipped with the „ANTI DRIP” function: the iron stops producing the steam when the
temperature is too low; it prevents water from dropping.
ATTENTION! The iron is equipped with the vertical (clothes hanger) ironing function. Do not iron
clothes on the body.