MotorVac TRANSTECH-1000 - Manual (Page 15)

Troubleshooting and Additional Help
Refer to the list below in the unlikely event that you have problems with
your TRANSTECH 1000 Transmission Service System.
Problem: Solution:
1. Unit does not power-up.
Inspect circuit breaker, reset if
necessary.
Check power cord for wiring breaks.
2. Pump runs but is not moving
fluid.
Check internal filters for obstruction.
3. Unit works in one mode but
not in others.
Possible problem with solenoid valves.
4. Unit will not start. Waste light
is on.
Check that waste fluid tank is not full.
Level switch located near top of waste
fluid tank may be stuck ‘on’.
ADDITIONAL HELP
Please verify that items above have been reviewed before
calling for additional assistance.
In the unlikely event that problems persist with the unit call
Technical Support, have your model and serial numbers
available before you call. Remember to send in your warranty
card.
In the U.S. Canada:
(800)
841-8810 Contact your local
(714) 558-4822 MotorVac distirbutor