MIDLAND GXT2050 - Manual (Page 8)

Model GXT2000/2050 Series
Page 8 www.midlandusa.com
To ensure you get maximum range:
l Be sure to use fresh or fully charged batteries - low batteries will
cause low power conditions.
l Be sure you are on a GMRS channel - FRS channels are
restricted by the FCC to low power.
l Be sure to set your radio to use Hi power.
GXT2000/2050 SERIES QUICK REFERENCE CHART
MONITOR
Pressing and holding the MONITOR button for 3 seconds will let you
hear noise so you can adjust the volume level of the radio when not
receiving a signal. This should be used to check activity on your
current channel before transmitting. Press and hold the MONITOR
button for 3 seconds again to get out of MONITOR mode.
SCAN
Your GXT2000/2050 Series can scan all 50 channels for activity. To
enter, quickly press the SCAN button. Repeat the same procedure to
exit. Your radio will rapidly scan each of the 50 channels and stop on
any active channel. Your radio will resume scanning after 4 seconds
when the channel is no longer active.
When you press the PTT button to transmit on an active channel, the
scanning function will stop and remain on the active channel for 10
seconds before resuming scan when PTT button is no longer
pressed.
To resume scanning, quickly press the
button.
MENU Channel eVOX
1~50
Privacy Roger Beep
On/Off
Call Tone
1~10
Vibrate
On/Off
WX Channel
1~10
Silent Operation
On/Off oF~9 Off
CTCSS
DCS
1~38
1~104
WX Alert On/Off
1~15 for GXT2050
Power
H/M/L
MENU Press and hold the
MENU button for
5 seconds
WX Scan
1~10
*** Only on Ch 1 ~ 22
Dual Watch
Channel
1~50
Off CTCSS DCS
1~38 1~104
*** Only on Ch 1 ~ 22
DUAL WATCH FUNCTION
Dual Watch
Privacy Whisper
On/Off
Press and hold
the DOWN
button for 5
seconds
SOS
/