MIDLAND CT790 - Manual (Page 8)

8
and have set the same CTCSS tone.
In frequency mode, press MENU + 15. The screen displays “R-CTC”.
Press MENU to enter the function. Press the ▲/▼ buttons to turn OFF this function or to select
a CTCSS tone from 67.0Hz to 254.1Hz, then press MENU to confirm. To return to the standby
mode press EXIT.
NOTE:
This transceiver has 50 CTCSS groups.
TRANSMIT WITH CTCSS (T-CTCSS) --- MENU 16
In standby mode, press MENU + 16. The screen displays “T-CTC”.
Press MENU to enter the function. Press the ▲/▼ buttons to turn OFF this function or to select
a CTCSS tone from 67.0Hz to 254.1Hz, then press MENU to confirm. To return to the standby
mode press EXIT.
NOTE:
This transceiver has 50 CTCSS groups.
RECEIVE WITH DCS (R-DCS) --- MENU 17
In frequency mode, press MENU + 17. The screen displays “R-DCS”.
Press MENU to enter the function. Press the ▲/▼ buttons to turn OFF this function or to select
a DCS code from D023N to D754I, then press MENU to confirm. To return to the standby mode
press EXIT.
NOTE:
This transceiver has 105 DCS groups.
TRANSMIT WITH DCS (T-DCS) --- MENU 18
In standby mode, press MENU + 18. The screen displays “T-DCS”.
Press MENU to enter the function. Press the ▲/▼ buttons to turn OFF this function or to select
a DCS code from D023N to D754I, then press MENU to confirm. To return to the standby mode
press EXIT.
NOTE:
This transceiver has 105 DCS groups.
SCAN FUNCTION (SC-REV) --- MENU 19
This transceiver has three Scan modes:
TO - Time-operated Scan
Whenever a signal is detected, the radio will suspend the scan for 5 seconds, and then will conti-
nue to scan even if the signal is still present.
CO: Carrier-operated Scan
Whenever a signal is detected, the radio will stop scanning. It will resume to scan once the signal
will be no more present.
SE: Search Scan
The radio will stop scanning and exit the Scan mode once detected a signal.
In standby mode, press MENU + 19. The screen displays “SC-REV”.
Press MENU to enter the function. Press the ▲/▼ buttons to select the desired Scan mode, then
press MENU to confirm. To return to the standby mode press EXIT.