MIDLAND CT790 - Manual (Page 14)

14
TABLE OF SOLUTIONS
PROBLEM SOLUTION
The radio doesn’t switch on
The battery may be exhausted. Recharge it.
Uncorrected installation. Re-install it.
Battery recharge doesn’t last long
The battery pack is over. Change it with a
new one.
Battery pack is not completely charged.
Reception led turns on but no sound heard
Make sure the volume is not too low
Make sure to have the same CTCSS and DCS
codes of your group
The keypad doesn’t work keypad lock function hasn’t been enabled.
In standby, the radio transmit without
pressing PTT
VOX level has been set too low. Adjust it.
Some functions cannot be stored
Ensure to be on Channel mode. In Channel
mode some functions can be set only through
the programming software.
Reception of other group signal while
transmitting
Change another CTCSS/DCS for your group