MIDLAND BT1 - Manual (Page 14)

14
LIGHT AND SOUND SIGNALS
LED indication Status
GENERAL
None
Unit is switched off or full charged when connected to the power supply
Single Blue flash every 3 seconds Unit being turned on/ Unit in working mode
Triple red flash Unit being turned off
Single Blue flash every 3 seconds
Single Red flash every 3 seconds
Standby
Standby - low battery
RED and BLUE (together) every 3
seconds
Active (Intercom, phone call or Bluetooth connection in progress)
RED and BLUE (together) and one flash
of RED light every 3 seconds
Active but low battery
Single red flash every 2 seconds Unit in charge when connected to the power supply
SETUP
Steady Red
Setup mode
Rapid Red-Blue alternating flash Pairing mode (searching for devices)
Steady Blue for two second Successful pairing/ Reset paired devices/Three way enabled/ Intercom always open
enabled
Blue light two time long flash Three way disabled/ Intercom always open disabled
Audio signals
Status
Ascending tone (low-high) Unit being turned on
Descending tone (high-low) Unit being turned off
Enable/Disable the Intercom 1 tone = enabled / 2 tones = disabled
1 tone Specific feature turned on
2 tones Specific feature turned off
UNIT FUNCTIONS
If you want to... …do this
GENERAL
Turn on the unit
Press the Intercom button for 3 seconds at least (start Blue flash)
Turn off the unit Press the Intercom and AUX button together for 3 seconds (triple Red flash)
Increase the volume Short or continues press on the Volume Up control
Decrease the volume Short or continues press on the Volume Down control
MOBILE PHONE (only driver’s unit)
Answer a call
Short press of the Phone button / say a word
Reject a call Long press the Phone Button / remain silent until the rings stop
Terminate a call Short press the Phone Button