Mody Pumps MS 121 User Manual
Page 2
L
L
I
I
F
F
E
E
I
I
S
S
P
P
R
R
E
E
C
C
I
I
O
O
U
U
S
S
-
-
T
T
H
H
I
I
N
N
K
K
S
S
A
A
F
F
E
E
T
T
Y
Y
1.
Most accidents can be avoided by using COMMON SENSE.
2.
Please read the operation and maintenance instruction manual supplied with the
pump. If you did not receive one, please call your local distributor before pump
installation.
3.
Do not wear loose apparel that may become entangled in the impeller or other
moving parts.
4.
Always use appropriate safety equipment, such as safety glasses, when working on
the pump or piping.
5.
Pumps build up heat and pressure during operation-allow time for pumps to cool
before handling or servicing.
6.
Only qualified service personnel should install, operate and repair pump.
7.
Keep clear of suction and discharge openings. DO NOT insert fingers in pump with
power connected.
8.
Do not pump flammable or hazardous materials (gasoline, acids, alkalis, etc.)
9.
Do not block or restrict discharge hose, as it may whip or burst catastrophically
under pressure.
10. Make sure lifting handles/hooks are securely fastened each time before lifting.
11. Do not lift pump by the power cord under any circumstances.
12. Do not exceed manufacturer's recommendation for optimum performance, as this
could cause the motor/pump to overheat and lead to premature wear or failure.
13. Secure the pump in its operating position so it does not tip over, fall or slide.
14. Keep away from impeller when power is connected.
15. Submersible Pumps are not approved for use in swimming pools, recreational water
installations, decorative fountains or any installation where human contact with the
pumped fluid is common.
16. Do not operate pump without adequate protection and safety devices in place.
17. Always replace safety devices that have been removed during service or repair.
18. To reduce risk of electrical shock, pump must be properly grounded in accordance
with the National Electric Code and all applicable state and local codes and
ordinances.
19. To reduce risk of electrical shock, always disconnect the pump from the power
source before handling or servicing.
20. Any wiring of pumps should be performed by a qualified electrician.
21. Never operate a pump with a power cord that has frayed or brittle insulation.
22. Cable should be protected at all times to avoid punctures, cuts, and
abrasions - inspect frequently.
23.
Never handle connected - "hot" power cords with wet hands.
24. Never operate a pump with a plug-in type power cord without a ground fault circuit
interrupter, adequate overload and short circuit protection.
IMPORTANT !!! MODY Pumps Inc. is not responsible for losses, injury, or death resulting
from a failure to observe these safety precautions, misuse or abuse of pumps or
equipment.
Mody Pumps Inc.
:
2166 Zeus Court, Bakersfield, CA 93308 Tel.: (661) 392-7600 Fax: (661) 392-7601