Mody Pumps MS 482 - Manual (Page 9)

• UNSCREW NUTS (4) HOLDING THE PUMP COVER AND PRY OUT THE SAME. REMOVE THE
WIRE CONNECTORS (45 & 46) TO SEPARATE THE POWER CABLE FROM THE MOTOR LEADS.
THE WIRE CONNECTORS CAN BE UNSCREWED COUNTER CLOCKWISE TO RELEASE THE SAME.
UNSCREW NUT FOR GROMMET (50) AND REMOVE RUBBER GROMMET (49). REMOVE BOLT
(47) AND PRY OUT UPPER BEARING BRACKET (8).
• THE STATOR IS NOW AVAILABLE FOR ELECTRICAL CHECKS, IF ANY ARE REQUIRED. WE
RECOMMEND MEASURING LINE TO LINE RESISTANCE BETWEEN THE THREE POWER LEGS, A
MEGGING TEST AND IF AVAILABLE A HIGH POT.
RE- ASSEMBLY OF THE PUMPSET.
THE PUMP CAN BE RE- ASSEMBLED BY REVERSING THE ABOVE PROCEDURE. PLEASE HOWEVER
NOTE THE FOLLOWING:
• ALWAYS REPLACE ELASTOMER ELEMENTS.
• REPLACE LOCK WASHER DURING RE –ASSEMBLY.
• CAREFULLY READ THE SEAL ASSEMBLY INSTALLATION INSTRUCTIONS PAGE.
OIL SPECIFICATIONS
A) EXXON UNIVOLT 61
B) SHELL TELLUS 29.
C) CHEVRON SUPERLA FDA APPROVED # 10
PLEASE NOTE THE SEAL CHAMBER CONTAINS APPROX. 2.5 LITRES OF OIL.