Mirion Technologies RC991 - Manual (Page 3)

CONtrOLLer FOr CaMera, PaN aND tILt, LIGHts
CaBLe (CaMera ONLY)
type Minikevlar
Diameter 11.3mm (0.44”)
Maximum length 100m (328 ft)
50m (164 ft) with high powered
lights
Camera Connector IST C991, 24 way
Controller connector Burndy Metalok Bantam, 28 way
CONtrOLLer FOr CaMera, PaN aND tILt, LIGHts
CaBLe (FOr PaN, tILt, LIGHts)
For other cable lengths with 3 x 75W lights, please contact Mirion
Technologies.
Note: Pan, Tilt, Zoom with Light requires TV36 cable. Minikevlar can
be used if lights are not required.
type TV36
Diameter 16.45mm (.64”)
Maximum length 50 metres (164 ft)
sPeCIFICatION NOtes
1. A “good” picture is defined as one where the
illumination available is sufficient for the camera to
produce a 1 volt composite video signal with a fully
open iris.
2. A “usable” picture can usually be obtained depending
on the scene viewed and environmental factors, etc.,
when the illumination available is only
1 /
2
that required
to achieve a 1 volt composite video signal with a fully
open iris.
OPtIONs
Pan and Tilt Equipment - Lighting
50 W 12 volt dc Safelight spot lamp •
50W 12 volt dc Safelight flood lamp •
75W 12 volt dc Safelight spot lamp •
75W 12 volt dc Safelight flood lamp •
CaMera CONtrOLLers - rC991 Cua POrtaBLe
CONtrOLLer
Width 400mm (15.75”) (including
carrying handle)
Height 96mm (3.78”)
Depth 340mm (13.39”) (excluding feet
and protective hood)
Power requirements 90V to 264V, 50/60Hz, 50VA
maximum (without lighting psu)
CaMera CONtrOLLers - CONNeCtOrs
aC power IEC 320
Camera Burndy Metalok Bantam, 28 way
Video output 75 ohm BNC
Y/C output 4 way mini DIN
CaMera CONtrOLLers - CONtrOLs
Power On/off (rear panel)
Image Lens motor speed, macro, focus,
iris, zoom
Lights Off/intensity
Camera Electronic focus
Auto gain control on/off
Colour temperature (red/blue)
Colour uniformity (pre-set control)
Indicators Power, Motor limit, Agc on,
Illumination level
CONtrOLLer FOr CaMera, PaN aND tILt, LIGHts
Width 438mm (19”)
Height 88mm (3.5”
Depth 359mm (14.1”), excluding
controls and connectors
CONtrOLLer FOr CaMera, PaN aND tILt, LIGHts
POWer reQuIreMeNts - CONNeCtOrs
aC power IEC 320
Camera Burndy Metalok Bantan 48-way
Video output 75 ohm BNC
Y/C output 4-way Mini DIN
CONtrOLLer FOr CaMera, PaN aND tILt, LIGHts
POWer reQuIreMeNts - CONtrOLs
Power On/off (front panel)
Image Lens motor speed, macro, focus,
iris, zoompAN
Pan and tilt Four controls (pan right, pan left,
up, down)
Indicators Power, motor limit, AGC on
illumination level