Minuteman M201130-01 (230V) 1500 Burnisher User Manual
Page 8
Parts and Instruction Manual
Page 5
USER MAINTENANCE INSTRUCTIONS
All service and repair should be performed by a qualified electrician. No user serviceable
components are employed in this equipment. No lubrication of the motor is required.
CORD STORAGE
While not in use storage can be accomplished by winding cord around handle assy. Cord should
be completely unwound during operation.
• Do not use with damaged cord or plug. If appliance is not working as it should, has been
dropped, damaged, left outdoors, or dropped into water, return to service center.
• Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
• Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or appliance with wet hands.
• Always unplug the machine when removing brush. This equipment should be stored indoors
and not exposed to rain.
PREVENTATIVE MAINTENANCE
This machine employs a motor carbon brush wear indicator light located on the rear of the motor
cover. This will illuminate when the carbon brushes are worn to the point of needing replacement,
service should be done by a qualified electrician.
OPERATION
This equipment is equipped with a trigger safety interlock. Refer to diagram pictured below.
- 2-Speed Models Only