Minuteman MRS Mercury Vacuum - Manual (Page 10)

Parts and Instruction Manual
Page 7
ASSEMBLY PROCEDURE FOR MRS-4
See Main Assembly MRS 4
1. Place water shutoff assembly No. 5 onto tank centering gasket around rim.
2. Place 1 to 1 adapter No. 4 onto tank, center and engage tank lid latches.
3. Install charcoal filter assembly No. 3 into adapter No. 2. Using latches place in assembly No. 4.
4. Place the vacuum motor lid assembly No. 1 onto tank making sure it seats all the way around the adapter rim.
MRS-4 is ready for the recovery of mercury contaminated liquids only.
5. Attach hose assembly and tools required for your job applications.
6. Turn on vacuum and spray anti-static spray into end of tool you are using, proceed with cleanup.
DO NOT USE THIS MACHINE TO PICK UP FLAMMABLE OR EXPLOSIVE LIQUIDS OR OTHER MATERIAL.
DO NOT USE THIS MACHINE IN AN EXPLOSIVE ATMOSPHERE.
PROCEDURE FOR CLEANING MRS-4
1. Check with your Health/Safety Department for the proper procedure for disposing mercury contaminated liquid which you
have recovered in the MRS-4 vacuum.
2. Unplug electric cord from electric service and remove vacuum lid assembly.
3. Remove charcoal filter assembly.
4. Remove 1 to 1 adapter.
5. Remove water shutoff assembly and wipe down underside of water shutoff. Place wiping material in plastic liner bag
with proper label.
6. Dispose of mercury contaminated liquid in vacuum tank in accordance with procedures set up by your Health/Safety
Department.
7. Wipe down inside of tank assembly, place wiping material in plastic liner bag.
8. Re-assemble MRS-4 following procedure above.