Midlite DÉCOR POWER JUMPER - Manual

Power
Jumper
™
HDTV Power Relocation Kit
The In-wall HDTV “Power Jumper™” Power Relocation cable is used to easily relocate power to your flat panel mounted on the wall from
a premise duplex powered receptacle nearby. The Power Jumper™ is prewired and requires no electrical wiring by the installer, and fastens
to standard backless electrical NEMA formatted mounting devices.
The Duplex Receptacle of the Power Jumper™ is installed behind the HDTV and the IEC end is located below in the same stud bay
mounted on the wall. Use a standard right angle IEC power cord set (available from MIDLITE) and plug it into the IEC power inlet of
the “Power Jumper™” and plug the other end (NEMA 3 Prong Plug) into a remote surge protector or electrical receptacle nearby.
* Multiple Patents Pending
www.midlite.com
Warehouse: 866 Warren Street, Fall River, MA 02721
Office Mail: PO Box 70189, No. Dartmouth, MA
ph. 508.676.5169 • toll free 800.606.5169 • fax 508.861.0105
MODEL:
• Part Number: PJ Y XR; Y = Color (White = W,
Black = B not yet available): XR = Length 7R = 7 ft.,
(custom lengths 8, 9, 10, 13, 15 feet or more).
• NEMA 5-15R Receptacle connected to a IEC 60320
CY14 power inlet.
SPECIFICATIONS:
• Electrical Rating: 15 Amp, 125 Vac, 60Hz.
• Cable Type; NM-B, 14-2 AWG.
CODE AND RATING COMPLIANCY:
• UL 817, CSA#22.2#21
• NEC Code: 250.146(D), Isolated Receptacles.
• NEC Article 300.15 (E) Integral Enclosure and
NEC 334.40 (B) Devices of Insulating Material and
other NEC code requirements suitable for its intended
application.
• Cable Type NM-B usage as defined in Article 334 of
the NEC.
• All Components are UL rated for its intended application.
Part No: PJW7R