Magnum Venus Plastech TALON Gun External Mix - Manual (Page 15)

Talon External Mix Gun Manual
Rev. 10/2013 Page | 15
Introduction:
This manual, the EXTERNAL MIX TALON GUN MANUAL, provides information you
need to perform simple maintenance and repair on your equipment.
 Step-by-step assembly and disassembly procedures are included for each
component.
Please read the manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
DANGER: Always wear proper safety equipment, including eye protection and gloves
when performing service and repair on this equipment.
During Disassembly:
As you disassemble the equipment, lay out the components on a clean surface in the
correct order and direction - this will help you to reassemble them. Have a current parts
drawing available for reference this assist in assembly and part numbers if parts need to
be ordered.
Tools required
You will need the following tools:

7/16-inch Socket Wrench * (08472)
– 7/16-inch Socket or Wrench

11/16-inch Socket or Wrench

Hex Wrench/Key Set * (08469)

8-inch Adjustable Wrench * (08467)

Flat-end screwdriver

Scribe set * (08126)
NOTE: Items followed by a * may be purchased from Magnum Venus Plastech.
You should also have appropriate cleaning materials such as solvent, clean shop towels
or rags, a small brush, and empty containers into which you will flush the gun.
Also, you will need the appropriate Seal kit for the gun you have and other items that
may need to be replace the current ones in the gun. Please refer to the parts drawings
to obtain proper parts numbers for the O-rings and Seals to be replaced.