Magnum Venus Plastech ATG Gel Coat Gun - Manual (Page 13)

ATG Chopper Gun Manual
Rev. 05/2012 Page | 13
Introduction:
The AT series guns are one of the most advanced state of the art guns introduced
into the composites industry. The AT gun series features low maintenance, few
adjustments, superb quality and a long service life. These guns will assist you in the
production of a superior product. The AT series guns are “air trigger” guns. As the
gun trigger is pulled air is shifted from one side of a piston to the other, the pistons
are attached to the gun needles and thus opens and closes the needles.
This manual, the ATG GEL COAT GUN MANUAL, provides information you need to
perform simple maintenance and repair on your equipment.
Step-by-step assembly and disassembly procedures are included for each
component.
A troubleshooting guide helps you diagnose and perform common repair
situations.
Please read the manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
DANGER: To prevent accidental injection injury, disconnect all air and
electrical power to the unit before beginning repair or maintenance on this
equipment.
During Disassembly:
As you disassemble the equipment, lay out the components on a clean surface in
the correct order and direction. This will help you to reassemble them.
This manual covers all the variations of the ATG Gel Coat Gun:
ATG-3500-XXX EXTERNAL MIX GEL COAT GUN
ATG-6500-XXX EXTERNAL MIX GEL COAT GUN – WITH SIGNAL