Magnum Venus Plastech High Duo Pro Gun User Manual
Page 19
MAGNUM VENUS PLASTECH HIGH VOLUME DUO PRO GUN
19
Remove Resin & Hardener Seals
1.
Insert the Seal installation tool into one of the side ports and gently tap it
completely through the Gun block with a rubber mallet or hammer. As the tool
is tapped through the interior of the gun block it will remove the seal sets for
both the Resin and the Hardener sides.
2.
Remove Hardener and Resin seal (relief spacer and secondary seal) from the
Seal installation tool. Clean with solvent.
CAUTION: Keep the components of the hardener side separate from the
components of the resin side. Mixing the components could result in cross-
contamination.
3.
Clean the two Relief spacers (58123-1) with solvent and allow to air dry.
4.
Discard the Resin seals and replace with new ones from repair kit.
Clean Gun Block Assembly
• Discard old o-rings and seals.
• Clean remaining components with solvent and allow to air dry.
• You have now disassembled the gun block.
GUN BLOCK
RELIEF SPACER
RESIN SEAL
SECONDARY SEAL
PACKING RING
PACKING NUT
SECONDARY SEAL
SEAL INSTALLATIOIN TOOL
RESIN SEAL
RELIEF SPACER
PACKING NUT
PACKING RING