Mach III Clutch V8G1K-STL, V8G2K-STL - Manual (Page 4)

7/9/2013 TORQLIM_MECH_W_COUPL_MANUAL Page 4 of 5
C. REASSEMBLY
(1) Replace the nut.
(2) Adjust to desired torque.
(3) Tighten nylon point set screw.
(4) See “torque Limiter Installation” portion of these instructions for the proper procedure
for reinstalling the clutch.
VII. Torque Setting Instructions
A. Product Numbers: V3G2H-STL, V4G2H-STL, V5G2H-STL and non-catalog
variations of this torque limiter design.
(1) Make sure the nylon-tipped set screw (REF. C) in the outside diameter of the adjustment nut
(REF. A) is loose.
(2) Make sure the adjustment nut (REF. A) is snug against the disc spring (REF. B).
(3) Using a spanner wrench, tighten the adjustment nut (REF. A) against the disc spring
(4) Check torque value after each 1/4-turn increment of the adjustment nut (REF. A) while holding
adapter/sleeve (REF. D) stationary and turning drive hub (REF. E) with a torque wrench.
(5) Tighten the nylon-tipped set screw (REF. C) in the outside diameter of the adjustment nut
(REF. A).
A
B
C
D
E