Lightronics FC816 - Manual (Page 7)

Page 7 of 7
FC - 816 CONTROL CONSOLE
Version 1.1
OWNERS MANUAL
02/20/2005
www.lightronics.com
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 Tel 757 486 3588
MAINTENANCE AND REPAIR
TROUBLESHOOTING
Make sure you have power to the unit. The unit is powered by an OPERATING dimmer connected via the MPX
cable.
Check that the multiplex cable is not defective.
To simplify troubleshooting - Reset the unit to set it to a known set of conditions.
Make sure that dimmer address switches are set to the desired channels.
OWNER MAINTENANCE
The best way to prolong the life of your controller is keep it dry, clean, cool, and covered when not in use. Since
the FC-816 is normally used as a foot operated controller it is particularly effective to cover it and/or move it up
away from the floor whenever possible.
There are no user servicable parts in the unit. Service by other than Lightronics authorized agents will void the
warranty.
The unit exterior may be cleaned using a soft cloth dampened with a mild detergent/water mixture or a spray-on
type cleaner. DO NOT SPRAY ANY LIQUID directly on the unit. DO NOT IMMERSE the unit in any liquid or
allow liquid to get in the unit or the controls. DO NOT USE any solvent based or abrasive cleaners on the unit.
OPERATING AND MAINTENANCE ASSISTANCE
Dealer and Lightronics factory personnel can help you with operation or maintenance problems. Please read the
applicable parts of this manual before calling for assistance.
If service is required - contact the dealer from whom you purchased the unit. If that is not possible - contact
Lightronics, Service Dept., 509 Central Drive, Virginia Beach, VA 23454. Tel. 757 486 3588.
UNIT SERIAL NUMBER
Lightronics recommends that you record the serial number of your unit for future reference.
SERIAL NUMBER: _______________________