P a c a – Lightronics AB0302A User Manual
Page 4
Page
4
of
10
AB-0602A ARCHITECTURAL BALLAST DRIVER
Version 0.10 OWNERS MANUAL 07/05/2012
www.lightronics.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
Va
234354
757
486
3588
SIMPLE REMOTE CONNECTIONS
Scenes 1 - 8 (stored in the AB-0602A) may be used
by simple remotes. A BLACKOUT function may
also be accessed. A simple remote is any switch that
can provide a momentary contact closure which can
be applied to a specific pin on the AB-0602A simple
remote controls connector.
See the
CONTROL SIGNAL CONNECTIONS
diagram for specific connection details. The three
COM
(commons) pins are electrically tied together.
A SIMPLE REMOTE COMMON is routed to the
remote switch. When the switch is operated the
closure brings the common back to the applicable
pin
(SW1 - SW8)
on the simple remote controls
connector in the AB-0602A. Contact SW9 is the
BLACKOUT. Almost any available low voltage
wire may be used since these connections are just
contact closures.
Multiple simple remotes may be used. Additionally
multiple AB-0602A units may be chained to one or
more simple remotes.
An example remote of switch operation using a
Lightronics APP01 switch is shown below. It can
activate scene 1 and invoke a blackout.
OPERATION
SETUP AND OPERATING CONFIGURATION
All operating functions and settings for the AB-
0602A are menu controlled using the LED Display
and the 4 buttons located below it on the control
circuit board.
FACTORY DEFAULT CONFIGURATION
The AB-0602A is supplied with a factory default
setup configuration. The unit may be reset to this
condition by keeping the
SELECT button held
down while power is applied. The display briefly
shows
FACt
while the reset is being performed.
The AB-0602A is set as follows when a reset is
performed:
1. The DMX pack address (
PACA
) will be set to
DMX address 1 (
P001
).
2. Softpatch is set to DMX addresses 1 - 6
3. Dropout trip points are set to 35 (14%).
4. All channels curves are set to
LED1
.
5. The architectural ID
(ArCU)
is set to
00.
DISPLAY STATUS INDICATORS
The LED display shows a dot near the upper left
corner when a valid DMX signal is being received.
MENU ACCESS AND USE
Hold the
MENU/NEXT button down for aprox. 5
seconds to gain access to the complete menu system.
If there is no button activity for 1 minute while
inside the menus then the unit will revert back to the
normal display (
PACA
).
To exit from anywhere in the menus - Hold down
MENU/NEXT for aprox. 5 seconds. The unit will
revert back to the normal display (
PACA
).
A menu/display operation flow diagram is provided
at the back of this manual.
CAUTION
REMOVE ALL POWER FROM THE AB-0602A
BEFORE MAKING OR CHANGING SIMPLE
REMOTE CONNECTIONS.
P A C A
MENU
NEXT
SELECT
DMX VALID
SIMPLE REMOTE
CONNECTION EXAMPLE