Menu, Chase# × 4ch seq – Lightronics RD121 User Manual
Page 8

Page 8 of 13
RD - 121 RACK MOUNT DIMMER
Version 1.2
OWNERS MANUAL
02/28/2005
www.lightronics.com
Lightronics Inc.
509 Central Drive, Virginia Beach, VA 23454
(757) 486-3588
MENU
1.
Push MENU 3 times. The LCD will appear as shown:
2.
Push SELECT. Then push MENU. The LCD will appear as shown: The bottom
display row shows the currently selected pattern. The pattern "4Ch Seq" is
shown as an example.
Chase# ×
4Ch Seq
3.
Use the UP and DOWN arrow buttons to scroll through the available chase
patterns. Push SELECT when the desired pattern appears.
Note:
Remember that this action does not activate the chase pattern. This action selects which pattern will be
run when activated by the remote switch function.
The available patterns are:
4 CHANNEL SEQUENCE
8 CHANNEL SEQUENCE
4 CHANNEL BUILD
12 CHANNEL SEQUENCE
6 CHANNEL SEQUENCE
RANDOM
6 CHANNEL BUILD
PROGRAMMABLE
CONTROLLING CHASER CHARACTERISTICS
You can control seven characteristics of a chase pattern. These controls are described as follows:
Chase Rate
The duration of each chase step (.25 - 999.75 Sec.).
Default = 1 Sec.
Chase Fade Rate
The time for each step to reach maximum intensity (0 - 100% of step time).
Default = 100%
Chase Intensity
The overall brightness of the chase (0 - 100%)
Default = 100%
Chase Steps
The maximum number of steps in the chase (1 - 32)
Default = 4
Chase Bounce
Causes reversal at the end of each sequence (Ignored during RANDOM).
Default = Off
Continuous /Single
Enables/Disables a "one shot" chase occurance (Ignored during RANDOM).
Default = Continuous
Activate Chase at power up
Enables chase to begin automatically when dimmer is turned on. **
Default = Off
** Overrides remote switch setting
The default setting is the factory set value.
All of these characteristics can be set via the RD-121 menu system. See the diagram STRUCTURE OF MENU
SYSTEM for a complete layout of menu system operation.