Lightronics AS40L - Manual (Page 2)

Page 2 of 6
AS-40L COMPACT DIMMER
Version U.1
OWNERS MANUAL
02/11/2005
www.lightronics.com
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 tel 757 486 3588
CHASSIS END VIEW
OPERATION
NORMAL MODE (non-chaser)
A green LED in the end panel will indicate that a valid control signal (LMX) is applied to the unit. A DIP switch
block on the end panel selects the starting channel number of the dimmer. The 7 right hand switches (numbered
4 -10) control this function. For example, if all switch positions are down - the dimmer will respond to console
channels 1-4. Moving the switch position on the far right to up will set the dimmer to respond to channels 5-8. A
complete table of channel assignments is provided at the end of this manual.
RELAY MODE: Pairs of channels (1/2 and/or 3/4) may be switched into the relay mode. In this mode the output
of these channels will be either off or full on depending on the control console channel setting. The trip point for
turn on is aprox. 50%. The 2 left hand switches on the DIP switch block control relay mode channel selection.
NORMAL MODE SWITCH FUNCTIONS
1/2 DIM/RELAY
(DOWN = DIM, UP = RELAY)
3/4 DIM/RELAY
NORMAL/CHASER
(DOWN FOR NORMAL)
CHASER MODE
ADDRESS
When operating in the chaser mode the AS-40L becomes independent of the control console and other dimmers.
The green LED indicator is OUT when in the chaser mode. Chaser mode is turned on and off by one of the DIP
switches on the end of the unit. A diagram on the unit cover shows the switch settings for controlling chaser
operation.
Eight different chaser patterns are available. A “bounce” condition may be imposed on several of the chase
patterns by setting one of the DIP switches. The bounce condition causes the chase pattern to run in alternating
directions.
The chase step time may be controlled for up to 64 seconds per step. Step fade time is proportional to the step
time. If a channel is in the relay mode during chaser operation - it will “snap” on and off (zero fade time). The
tables below show the details of chaser settings.