Cr100 universal remote control, En g li s h – Arcam AVR280 User Manual

Page 19

AVR280

��

��

��

��

�

��

CR100 Universal remote control

NOTE
Remember to install the four AAA batteries supplied
before trying to use your remote control.

The CR100 is a ‘universal’ remote that controls the AVR280 and up to
seven other devices. The instructions on this page only refer to the
control of the Arcam AVR280.
For information on using the remote control for other devices, and a
full list of its features, see the Handbook supplied with the CR100.

Device selection
IMPORTANT: Press the ‘AMP’ button first to
operate the AVR280.

On/Stand-by
This allows the AVR280 to be put into and taken
out of stand-by remotely.
If you do not wish to put Zone 2 into stand-by at
the same time as the main zone, press and hold
the stand-by button on the remote control for
more than 3 seconds.

MENU
Press to select the OSD Main menu.
Press and hold for more than three seconds to
select the ‘Set-up Menu Index’.

TAPE
Selects Tape input for the amplifier

Navigation buttons
Arrow buttons allow navigation around the Basic
and Advanced Set-up menus on the AVR280.
Confirm a selection by pressing

SHIFT

to Power on

SHIFT

to Power off

SHIFT

to switch Zone 2 on

SHIFT

to switch Zone 2 off.

Source selection only

DVD input

CD player input

Television (sound) input

Auxiliary (line) input

Video Cassette Recorder input

Satellite decoder input

DAB/FM/AM tuner input

Press the relevant button once to select input.

MUTE
Press once to mute the main system. Press again
(or use

VOL +/–

) to un-mute.

VOLUME +/–
Adjusts the sound output.

MODE
Cycles through available audio surround modes.

Source selection and handset configuration

DVD

DVD input/DVD commands

SAT

Satellite decoder input/SAT commands

Television (sound) input/AV commands

TUN

Radio tuner input/TUN commands

AMP

Amplifier. Press first to operate the AVR280

AUX

Auxiliary (line) input/AUX commands

VCR

Video Cassette Recorder input/VCR
commands

CD player input/CD commands

Press the relevant button once to select input and
reconfigure the handset. Press and hold to select
the input without reconfiguring the remote.

DISP (Display)
Press to cycle through Off/Dim/Bright illumination
of the front panel display

If the tuner is in Preset mode, these buttons give
the next Preset radio station down (

) or up

(

). If the tuner is in Tune mode, these buttons

decrease/increase the tuning frequency.

AVR-specific controls
These buttons are described on the next page.