Level Mount DC42SM - Manual (Page 3)

Figure 12
Figure 13
Figure 14
Figure 15
Remote
Control
Attaching Mounting Arms to Wall Mount:
Place locking levers on mounting arm in horizontal position 1.
(Figure 12),
Slide arms with TV over mounting plate (Figure 13).
2.
Rotate Locking Levers to vertical position (Figure 14) to 3.
secure TV to mount.
TV may be moved from left to right for final location.
4.
Plug in AC power adapter to bottom of mount and wall outlet. 5.
(Figure 15)
Locking TV to Mount:
With locking lever in locked position, add padlock to prevent 1.
theft or accidental movement of lever. (Figure 16)
Figure 16
Using Cord Management:
Use Velcro strap at bottom of mount to secure all wires and 1.
cables. Make sure to leave enough wire above strap to allow
free movement of mount! (Figure 17)
Figure 17
Using Remote Control:
Press center button once to extend mount from wall 1.
Adjust mount as desired. 2.
Press center button again to return mount to seated position 3.
(mount will realign before moving back to wall)
Press top button to tilt mount up. (mount will
not tilt upward from parallel to wall)
Press bottom button to tilt mount down.
Press left button to pan mount left.
Press right button to pan mount right.
AAA x 3 Magnetic Holder
Back of Remote
Battery Cover
Note: Photos taken without TV
or mounting arms installed
Top View
Top View
Side View
Side View
Side View
www.LevelMount.com
1-888-229-1459
©2008 Level Mount
Patents Pending