Lectrosonics DM812 User Manual
Page 4
DM Series Installation Guide
LECTROSONICS, INC.
4
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. The equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that which the receiver
is connected
• Consult the dealer or an experienced radio/TV technician for help
Changes or modifications to this equipment not expressly approved by Lectrosonics, Inc.
could void the user’s authority to operate it.
Table of Contents
Important Safety Instructions................................................ 3
Introduction ............................................................................. 5
Unpacking the Unit ................................................................ 5
Items Included in the Box: ..................................................... 5
Hardware Installation ............................................................. 6
Installing the DM System into a Rack ................................... 6
Audio Inputs ......................................................................... 6
Audio Outputs ....................................................................... 7
Programmable Inputs ............................................................ 8
.............................................................................................. 8
Programmable Outputs ......................................................... 8
Expansion I/O ports .............................................................. 8
Master/Slave Configuration ................................................... 9
Control System Interconnections ........................................ 11
Software and USB Driver ................... 12
Installation with LecNet2 Device Installer ........................... 12
Manual Installation .............................................................. 13
Initial Setup ........................................................................... 14
Initial Setup Hints ................................................................ 15