Lectrosonics UT400 - Manual (Page 17)

Synthesized UHF Hand-Held Transmitter
Specifications
Operating frequencies:
Frequency selection:
Channel Separation:
RF Power output:
Pilot tone:
Frequency stability:
Deviation:
Spurious radiation:
Input limiter:
Gain control range:
Modulation indicators:
Block 21 537.600 - 563.100 Low frequency roll-off: -3 dB @ 70 Hz, 36 dB/octave
Block 22 563.200 - 588.700 Audio frequency response
Block 23 588.800 - 607.900 and (overall system): 80 Hz to 20 kHz (+/- 1 dB)
614.100 - 614.300
Controls:2 position “OFF-ON” slide Power switch for
Block 24 614.400 - 639.900
noiseless turn on/off operation.
Block 25 640.000 - 665.500
Audio Level Control in Battery Compartment
Block 26 665.600 - 691.100
adjusts audio gain. Two rotary switches in
Block 27 691.200 - 716.700
Battery Compartment adjust transmitter
Block 28 716.800 - 742.300
operating frequency.
Block 29 742.400 - 767.900
Battery: Precision compartment auto-adjusts to
256 frequencies in 100 kHz steps
accept any known alkaline 9 Volt battery.
100 kHz
Battery Life: 3.5 hours (alkaline); 6.5 hours (lithium)
100 mW (nominal)
Weight: 12.4 oz.. with VariMic™ capsule and
25 to 32 kHz frequency
lithium battery
(400 Series Compatibility Mode only);
Dimensions: 9” long x 2.05” diameter at largest point
5 kHz deviation
± 0.002%
± 75 kHz (max)
Emission Designator: 180KF3E
90 dB below carrier
Dual envelope limiter, >30 dB range
Specifications subject to change without notice.
43 dB; semilog rotary control
Dual bicolor LEDs indicate modulation
of -20, -10, 0 and +10 dB
referenced to full modulation.
The FCC requires that the following statement be included in this manual:
This device complies with FCC radiation exposure limits as set forth for an
uncontrolled environment. This device should be installed and operated so that its
antenna(s) are not co-located or operating in conjunction with any other antenna or
transmitter.
Rio Rancho, NM 17