Lectrosonics MM400 - Manual - Manual (Page 11)

Frequency Agile UHF Miniature Belt-Pack Transmitter
SPECIFICATIONS AND FEATURES
Operating frequencies: 537.600 to 607.900 MHz
614.100 to 793.500 MHz
Frequency selection: 256 frequencies in 100kHz steps
RF Power output: 100 mW (nominal)
Pilot tone: 25 to 32 kHz; 5kHz deviation
Frequency stability: ± 0.002%
Deviation: ± 75 kHz (max)
Spurious radiation: 90 dB below carrier
Equivalent input noise: –118 dBV, A-weighted
Input level: Nominal 2 mV to 300 mV, before limiting.
Greater than 1.5V maximum, with limiting.
Input impedance: 2 kOhm
Input limiter: Soft limiter, >30 dB range
Gain control range: 43 dB; semi-log rotary control
Modulation indicators: Dual bicolor LEDs indicate modulation of –20, -10, 0, +10 dB referenced
to full modulation.
Low frequency roll-off: –12dB/octave; 70 Hz
Controls: Front panel knob adjusts audio gain.
Rotary switches on bottom panel adjust transmitter frequency.
Audio Frequency Response: 32 Hz to 20 kHz (+/-1dB - overall system)
Audio Input Jack: 2.5 mm Locking micro (matches Switchcraft 850 Microplug)
Antenna: Detachable, flexible bronze wire supplied. 50 Ohm port allows
connection to test equipment.
Battery: 1.5 Volt AA lithium recommended
Battery Life: Alkaline: 2 hours
Lithium: over 5 hours (typical)
Weight: 7.3 ozs. including battery
Overall Dimensions: 3.03 x 2 x 0.69 inches (not including microphone or antenna)
Emission Designator: 180KF3E
Specifications subject to change without notice.
The FCC requires that the following statement be included in this manual:
This device complies with FCC radiation exposure limits as set forth for an uncontrolled environment. This device
should be installed and operated so that its antenna(s) are not co-located or operating in conjunction with any other
antenna or transmitter.
Rio Rancho, NM – USA 11