Lectrosonics UDR200c - Manual (Page 23)

23
Wireless Diversity Receiver
Rio Rancho, NM – USA
Set Lock Status - Sets the front panel lock status of the receiver.
Host sends command - 7 (7 hex)
Host sends data byte - 0=hard locked, 1=not locked, 2=locked
Get Lock Status - Gets the front panel lock status of the receiver.
Host sends command - 8 (8 hex)
Host receives data byte - 0=hard locked, 1=not locked, 2=locked
Set Channel Group - Selects the active channel group.
Host sends command - 9 (9 hex)
Host sends data byte - 1-4 selects group 1 thru 4
Get Channel Group - Reads the active channel group.
Host sends command - 10 (A hex)
Host receives data byte - 1-4 indicates group 1 thru 4
Get Firmware Revision - Reads the firmware revision.
Host sends command - 25 (19 hex)
Host receives data byte - firmware revision times ten (e.g. 10 for rev 1.0)
Get Optiblend Status - Retrieves dynamic diversity system status information.
Host sends command - 28 (1C hex)
Host receives 2 bytes - analog optiblend values (0-255) for antennas A and B
Set Remote Mode - Places receiver in a mode suitable for serial remote control (or restores normal operation
afterwards). In remote mode, a text message is displayed on the receiver’s front panel display and the front
panel buttons will not operate the receiver.
Host sends command - 30 (1E hex)
Host sends byte - 0 for normal mode, 3 for remote mode
If remote mode is selected, Host Sends 13 more bytes containing the text to be displayed on the receiver’s
alphanumeric display.
Get Pilot Bypass - Retrieves the status of the pilot tone bypass feature.
Host sends command - 53 (35 hex)
Host receives data byte - 0=not bypassed, 1=bypassed
Set Pilot Bypass - Sets the status of the pilot tone bypass feature.
Host sends command - 54 (36 hex)
Host sends data byte - 0=not bypassed, 1=bypassed