Lectrosonics UDR200c - Manual (Page 10)

10
USING THE LED INFORMATION DISPLAY
OPERATING MODES
The UDR200C has four display pages, or operating modes.
• Frequency and Battery Voltage
• Frequency and TV Channel
• Frequency Name
• Active Group and Lock Status
The MENU key may be used to cycle through the four modes.
Tuning Modes
In all but the Active Group and Lock Status mode, the re-
ceiver displays tuning information and the UP and DOWN
buttons change the tuning.
The UDR200C can tune to 256 channels in all, but special
groups of channels may be programmed for quick, convenient
access. The UDR200C has four groups or banks of selected
frequencies. At any given time, one of these groups is se-
lected or active. Each group contains up to 16 named fre-
quencies. As shipped from the factory, these groups are
preprogrammed with selected intermod-free frequencies, but
these can be changed with the accompanying UDRpanel
software to suit individual needs.
FREQ
SELECT
POWER MENU
Pressing the UP or DOWN buttons causes the receiver to jump
up or down to the next named frequency in the active group.
The buttons auto-repeat if held down. An attempt to tune up
from the highest named frequency in the group, or down from
the lowest named frequency, will do nothing. If the active
group has no named frequencies in it, the receiver will tune to
the next higher or lower adjacent channel.
FREQ
SELECT
POWER MENU
Holding down the MENU key while pressing the UP or DOWN
buttons causes the receiver to tune to the next higher or lower
adjacent channel, regardless of any named frequencies in the
active group. The buttons auto-repeat if held down. An at-
tempt to tune down from 00 or up from FF does nothing.
0 V
A
500 250 100 50 25 10 5 1uV 2 1mV OPTI
BLEND
500 250 100 50 25 10 5 1uV 2 1mV
OPTI
BLEND
B
LIM 0 -6 -12 -18 -24 -30 -36 -42 -48
TX AUDIO LEVEL dB RF LEVEL
RF LEVEL
FREQ
SELECT
POWER
MONITOR MODE
A B
DIVERSITY
MENU
6 6 8 . 1 0 8 . 7 1 9
The UDR200C has two power up options and four operating
modes which control all aspects of the receiver operation.
POWER UP OPTIONS
Set/Reset Hard Lock Mode - Holding down the MENU button
while powering on the receiver will switch the receiver between
the UNLOCKED mode and the HARD LOCKED mode.
FREQ
SELECT
POWER MENU
In the UNLOCKED mode, all receiver menu options may be
adjusted. In the HARD LOCKED mode, the MENU button may
be used to scroll through the menus, but no adjustments may
be made.
Set LecNet Address - Holding down the DOWN button while
powering on the receiver allows the LecNet address of the
receiver to be set.
FREQ
SELECT
POWER MENU
Setting each UDR200C to a unique address is required when
more than one receiver is connected to a PC. The address
setting should be accomplished before using the UDRpanel
software. UDR200Cs are shipped from the factory with a
LecNet address of 150. Multiple UDR200Cs in a system
should be assigned unique addresses. You will see the follow-
ing displayed on the LED display of the UDR200C in the
address setting mode:
L E C N E T A D D R 1 5 0
Use the UP and DOWN buttons to set the receiver to an
unused address. Then press the MENU button. This will store
the new address, and put the UDR200C in its normal operating
mode.