Jointed whip antennas, Amj kit cutting template – Lectrosonics SRa Series User Manual
Page 14
SRa5P and SRa Dual Receivers
LECTROSONICS, INC.
14
The hinged joint pivots in both
directions
32
470
944
33
31
21
22
23
24
25
26
27
28
29
30
20
19
AMJ KIT CUTTING TEMPLATE
Lay uncut antenna on this template and cut to length for the desired frequency block
Note: Check the scale of your printout. This line should be 6.00 inches long (152.4 mm).
Whip Length
Trim the end of the color cap and slide the remaining sleeve over the whip - OR - Glue color cap onto the end
*Cut end of cap off
and slide over whip
Frequency Blocks
*Color cap
Jointed Whip Antennas
The AMJ antenna is a general purpose design for any
Lectrosonics receiver or transmitter with a standard
SMA connector. The hinged joint pivots in both direc-
tions for positioning the whip at any desired angle.
470
470.100 - 495.600
Black w/ Label
5.56”
141.2 mm
19
486.400 - 511.900
Black w/ Label
5.27”
133.9 mm
20
512.000 - 537.500
Black w/ Label
4.93”
125.2 mm
21
537.600 - 563.100
Brown w/ Label
4.71”
119.6 mm
22
563.200 - 588.700
Red w/ Label
4.48”
113.8 mm
23
588.800 - 614.300
Orange w/ Label
4.27”
108.5 mm
24
614.400 - 639.900
Yellow w/ Label
4.07”
103.4 mm
25
640.000 - 665.500
Green w/ Label
3.87”
98.3 mm
26
665.600 - 691.100
Blue w/ Label
3.68”
93.5 mm
BLOCK FREQUENCY
CAP/SLEEVE
ANTENNA
RANGE
COLOR
WHIP LENGTH