L-com HG5822P - Manual (Page 2)

(Shown for Down-Tilt Mounting)
Mounting
This antenna can be mounted in a up or down tilt
position based on how the L-Bracket is attached
to the mast. The above photo shows the correct
orientation for down-tilt mounting (for up-tilt, rotate
L-Bracket 180 degrees).
Attach the L-Bracket to mast using supplied U-Bolt
and hardware. This mounting kit can be used with
masts 1.25" (32mm) to 2.12" (54mm) O.D.
L-Bracket
U-Bolt
Mast Clamp
Orientation Label
Drain Hole
Locations
Drain Hole Locations
O
Drain Hole Locations
Vertical or Horizontal Polarized Mounting
This antenna can be vertical polarized or horizontal polarized
mounted. To mount antenna, attach to L-Bracket as shown
using supplied hardware. Note orientation label on rear of antenna
for proper mounting.
To help prevent moisture build-up inside the antenna, drain holes
are provided. To ensure proper draining, these holes must be
orientated on the bottom of the antenna as shown.
INSTALLATION INSTRUCTIONS: HG5422P, HG5822P
IP-00058 Rev. B – 03/07 Page 2/2
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.
www.L-com.com