L-com HG2418D - Manual (Page 2)

IP-00089 Rev. A – 01/07 Page 2/2
2. Attach the Feed Reflector to the Feed Horn and
secure with Self-tapping screw included. Then
insert Feed Horn assembly into the front of the
dish and secure with Retaining Nut (see above).
3. Secure antenna assembly to mast using U-Bolts,
Clamp and hardware. (Note: Only one U-Bolt is
required when using tilt feature of L-Bracket)
Antenna can be mounted in a tilt position. See
Below for mounting options.
U-Bolt
Feed Horn
Dish
Installation Instructions
Model: HG2418D
Rear View
Installation Note: The Feed Horn can be oriented
for either vertical or horizontal polarization (vertical
polarization shown in photo). For horizontal polarization
rotate Feed Horn Assembly so that the Feed Reflector
is orientated horizontally, then insert assembly into dish.
L-Bracket
Clamp
L-Bracket
Mast
L-Bracket shown for down-tilt mounting. For up-tilt,
rotate bracket 180 degrees when attaching to antenna.
Feed Reflector
(shown vertical)
Self-Tapping
Screw
(Shown for Vertical Polarization)
Retaining
Nut
1. Attach the L-Bracket to the rear of the dish using
the 4-sets of screws included (see below).
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.