L-com HG2418P - Manual (Page 2)

IP-00021 Rev. A – 03/04 Page 1/2
INSTALLATION INSTRUCTIONS: HG2418P
Open Drain Hole
on bottom
Figure B
Horizontal Polarized Position
Drain Hole Plug
Figure A
Vertical Polarized Position
(As shipped from factory)
Open Drain Hole
on bottom
Drain Hole Plug
Mounting
1. Mount the antenna as shown, ensuring U-Bolt nuts are securely
tightened to prevent antenna shift in high wind.
2. The antenna can be mounted in a up or down tilt position from 0-60°.
See below for mounting options.
L-Bracket Mounting Options
Vertical or Horizontal Polarized Mounting
1. This antenna can be vertical polarized mounted (Figure A) or horizontal
polarized mounted (Figure B). It is shipped from the factory in the vertical
polarized position.
2. To mount the antenna in the horizontal polarized position, rotate antenna into
the position shown in Figure B. Note orientation label on rear of antenna.
3. Remove the drain hole plug from current location and replace into position
shown.
4. Attach antenna to L-Bracket using the (4) pan head screws.
Fixed
Mounting
20°
30°
0°
10°
40°
50°
60°
Variable
Mounting
0°-60°
Fixed 0° Mounting
L-Bracket shown for down-tilt mounting. For up-tilt,
rotate bracket 180 degrees when attaching to antenna.
www.L-com.com
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.