Ha2401-g11fnfpcx_7 – L-com HA2401-G11FNFPCX User Manual

Page 7

Install the Antenna

NOTE: THE ANTENNA SYSTEM SHALL BE INSTAL LED ONLY BY EXPERIENCED
ANTENNA INSTALLERS WHO ARE FAMILIAR WITH LOCAL BUILDING AND SAFETY
CODES, AND WHEREVER NECESSARY HAVE BEEN LICENSED BY APPROPRI ATE
GOVERNMENT REGULATORY BODIES. FAILURE TO DO SO MAY VOID THE PRODUCT
WARRANTY, AS WELL AS EXPOSE THE END-USER TO LEGAL AND/OR FINANCIAL
LIABILITIES. HYPERLINK TECHNOLOGIES, ITS AGENTS, RESELLERS OR
DISTRIBUTORS, ARE NOT LIABLE FOR INJURY, DAMAGE, OR VIOLATION OF
GOVERNMENT REGULATIONS THAT MAY ARISE FROM FAILING TO COMPLY WITH THE
GUIDELINES DESCRIBED IN THIS DOCUMENT.

Mount the antenna according to the specific installation instructions for the model you
are installing. When choosing the antenna site you must observe the following exposure
limits:

The table contained in Appendix A of this manual identifies which antennas
are considered “fixed” and which are “mobile”. When this device is
installed as a fixed-mount application there is a minimum required
separation distance of one hundred (100) cm between the antenna and all persons
during normal operation. All mobile antennas must be mounted at a
minimum distance of 20 cm from users.

Once the antenna is installed connect the antenna to the amplifier and signal filter (as
applicable) using the antenna cable.

Connect the Ethernet cable to the AP. For configuration, use an Ethernet crossover and
connect directly to a PC.

Apply power to the Access Point unit. Check the diagnostic lights to ensure proper
connection.

You should now be ready to configure the Access Point.

Use the Scan Tool to determine the MAC and IP Address for the AP

Install the Scan Tool program on the PC you will be using to configure the AP over the
Ethernet segment.

Run the Scan Tool to determine the MAC Address and default IP Address for the AP.

You can use the Change Screen to change the IP Address, Subnet Mask and Gateway IP
Address as required.

For more detailed information about installing and running the Scan Tool, refer to the
AP-2000 User Guide.

L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845

WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484