Ha2401-g11fnfpcx_10 – L-com HA2401-G11FNFPCX User Manual

Page 10

Setting and Changing Security Passwords

Note: Configure the following passwo rds by entering a password in both the Password
field and the Confirm field:

SNMP Read Password – The password for read access to the AP using SNMP.

SNMP Read-Write Password – The password for read and write access to the AP using
SNMP.

SNMPv3 Authe ntication Password – The password used when sending authenticated
SNMPv3 messages. Secure Management (Services Tab) must be enabled in order to
configure SNMPv3.

SNMPv3 Privacy Password - The password used when sending encrypted SNMPv3
data. Secure Mana gement (Services Tab) must be enabled in order to configure
SNMPv3.

Telnet (CLI) Password – The password for the CLI interface (via serial or Telnet).

HTTP (Web) Password – The password for the Web browser HTTP interface.

For security purposes make sure you set ALL PASSWORDS during installation.

IP Access Table

The Management IP Access Table limits in-band management access to the IP
addresses or range of IP addresses specified in the table. This feature applies to all
management options (SNMP, HTTP, and CLI) except for CLI management over the
serial port. To configure this table, enter the IP Addresses and IP Masks for the desired
addresses or range of addresses. Refer to the AP-2000 User Guide for further
information.

Configuring WEP and WPA

Each wireless interface can be configured to operate in WEP Encryption mode, 802.1x
Security Mode, Mixed (802.1x and WEP) Mode, WPA Mode and WPA-PSK (Pre-shared
Key) Mode. The Security mode selection is accessed through the Advanced
Configuration menus. Refer to the AP-2000 User Guide for further information.

Once the AP settings have been configured, apply power to the amplifier by plugging in
the appropriate DC power supply. Check the diagnostic LEDs to ensure proper
connection.

L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845

WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484