L-com HA2401-G11FNFPC - Manual (Page 8)

Configure the AP’s Basic Wireless Operations Settings
The first time you connect to the AP using the HTTP interface, the Setup Wizard
launches automatically. It provides instructions for how to configure the Access Point’s
basic operating parameter including Network Name, IP Parameters, RF Parameters,
System Parameters and Management Passwords.
To access the setup screens, first open a Web browser on the configuration PC. It may be
necessary to disable the browser’s Internet Proxy Settings if set. Enter the IP Address of
the AP in the browser’s address line and press Enter.
When the Security screen appears you will need to log in. Leave the User Name blank.
The default login password is public.
Using the configuration screens configure the basic operating parameters below:
Network Name (SSID): Enter a Network Name (between 2 and 31 characters long) for
the wireless network.
Auto Channel Select: You must disable this feature in order to manually set the
operating channel.
Frequency Channel: Select an authorized frequency channel based upon the specific
antenna used from the table in Appendix A.
Transmit Rate: Use the drop-down menu to select the Auto-Fallback option.
WEP Encryption: Place a check mark in the box provided to enable WEP encryption.
See WEP Encryption in the AP-2000 User Guide for more information about WEP and
Encryption Keys.
Set Encryption Key 1: If you enable Encryption, configure an Encryption Key. See
WEP Encryption in the AP-2000 User Guide for more information about WEP and
Encryption Keys.