Laurel Electronics Laureate Digital Panel Meter for Process, Strain & Potentiometer Follower Signals User Manual
Page 5
LAUREL
ELECTRONICS INC., 3183-G Airway Ave., Costa Mesa, CA 92626, USA • Tel 714-434-6131 • www.laurels.com 5
Ordering Guide
Create a model a model number in this format: L10000P, IPC
DPM Type
L Laureate Digital Panel Meter
1 Standard Main Board, Green LEDs
2 Standard Main Board, Red LEDs
3 Extended Main Board, Green LEDs
4 Extended Main Board, Red LEDs
Main Board
Note: Extended capability is required for custom curve linearization or for display of
time rate of change, such as flow rate from changing tank level or acceleration from
changing speed.
Power
(isolated)
0 85-264 Vac
1 12-32 Vac & 10-48 Vdc.
Relay Output
(isolated)
0 None
1 Two 8A Contact Relays
2 Two 120 mA Solid State Relays
3 Four 8A Contact Relays
4 Four 120 mA Solid State Relays
Analog Output
(isolated)
0 None
1 Isolated 4-20 mA, 0-20 mA, 0-10 V, -10 to +10V
Digital Interface
(isolated)
0 None
1 RS232
2 RS485 (dual RJ11 connectors)
4 RS485 Modbus (dual RJ45 connectors)
5 USB
6 USB-to-RS485 converter
7 Ethernet
8 Ethernet-to-RS485 converter
Process Signals (e.g., 4-20 mA, 0-5 V)
P
Field scalable. Default Scaling is 4-20 mA = 0-100.00
P1 Custom Scaling. In the write-in field of your invoice, specify min input, min
reading; max input, max reading.
Strain Gage, Potentiometer Follower (4-wire ratio)
SG Field Scalable. Default Scaling is 0-200 mV = 0-100.00
SG1 Custom Scaling. In the write-in field of your invoice, specify min input, min
reading; max input, max reading.
Signal Input
(isolated)
Note: The same DC signal conditioner board can be user-configured for process,
strain, potentiometer follower, DC Volts and DC Amps. It is precalibrated in EEPROM
for all Laureate DC Volt and DC Amp ranges.
Add-on Options
BL
Blank Lens without Button Pads
CBL01 RJ11-to-DB9 Cable
CBL02 USB-to-DB9 Adapter
CBL05 USB Cable, A to B
IPC
Splash-proof Cover
BOX1 NEMA-4 Enclosure
BOX2 NEMA-4 Enclosure plus IPC