Laurel Electronics Laureate Digital Panel Meter for Load Cell & Microvolt Input - Manual (Page 5)

LAUREL ELECTRONICS INC., 3183-G Airway Ave., Costa Mesa, CA 92626, USA • Tel 714-434-6131 • www.laurels.com 5
Ordering Guide
Create a model a model number in this format: L10000WM, IPC
DPM Type L Laureate Digital Panel Meter
1 Standard Main Board, Green LEDs
2 Standard Main Board, Red LEDs
3 Extended Main Board, Green LEDs
4 Extended Main Board, Red LEDs Main Board
Note: Extended capability is only required for custom curve linearization or for
display of time rate of change, such as flow rate from changing tank weight.
Power
(isolated) 0 85-264 Vac
1 12-32 Vac or 10-48 Vdc
Relay Output
(isolated) 0 None
1 Two 8A Contact Relays
2 Two 120 mA Solid State Relays
3 Four 8A Contact Relays
4 Four120 mA Solid State Relays
Analog Output
(isolated) 0 None
1 Isolated 4-20 mA, 0-20 mA, 0-10 V, -10 to +10V
Digital Interface
(isolated) 0 None
1 RS232
2 RS485(dual RJ11 connectors)
4 RS485 Modbus (dual RJ45 connectors)
5 USB
6 USB-to-RS485 device server
7 Ethernet
8 Ethernet-to-RS485 device server
Signal Input
(isolated) Load Cell (6-wire ratio)
WM
Field Scalable. Default scaling is 0-20 mV = 0-100.00
WM1 Custom Scaling. In the write-in field of your order, specify min input, min
reading; max input, max reading. Full-scale input is 20-500 mV. Excitation is
10 V for up to four 350-ohm load cells.
Add-on Options BL Blank Lens without Button Pads
CBL01 RJ11-to-DB9 Cable
CBL02 USB-to-DB9 Adapter
CBL05 USB Cable, A to B
IPC
Splash-proof Cover
BOX1 NEMA-4 Enclosure
BOX2 NEMA-4 Enclosure plus IPC